Blood for the Baron!

meertoh wrote:I'm sure this set will be popular here.

http://www.action-figure-supplies.co.uk ... t-marksmen

Aye, I fancy those and the VAMP, would look good with SAS stickers on..........

Just added to the site: 3D printed reproduction Roboskull chin guns!
http://www.action-figure-supplies.co.uk ... production

Very nice, I'll have to check my fleet out but I think these are all in place, would 3D printing work for the 'feet' ?

Hmm wonder if these would work out well in any customs????

What orientation are these printed at if you don't mind me asking? Concerned that if the layers are on the inserted part that they could tear and leave a bit stuck in the skull...

steve wrote:Very nice, I'll have to check my fleet out but I think these are all in place, would 3D printing work for the 'feet' ?

Hmm wonder if these would work out well in any customs????

I'm working on some 3D feet but they're a lot trickier to model. I might have to wait until I can get some laser scanned.

The Kraken Wakes wrote:What orientation are these printed at if you don't mind me asking? Concerned that if the layers are on the inserted part that they could tear and leave a bit stuck in the skull...

They're printed from the flat bottom of the gun upwards towards the tip afaik.

Will you be doing Red Shadow Bazookas? (PS did my email arrive?)

I hadn't thought of doing bazookas but it's a possibility.
Yes got your email, haven't had time to look at it yet though!

Or you could just buy an original...
http://www.action-figure-supplies.co.uk ... ow-bazooka

More temptation......