Blood for the Baron!

I'm going to the supermarket tomorrow, I think I'll test Krackens way.
If it doesnt work I guess I'll just rebase coat them a few times like Red Laser says.
Really appreciate all the help guys.

A spray paint primer should cover all previous colours without losing the fine details - but do be sure to hold the can far enough away from the figure or you'll just blast it.

And spray outside there is nothing worse than sniffing up the fumes of spray paint an hour or so after using them.

Red Laser wrote:And spray outside there is nothing worse than sniffing up the fumes of spray paint an hour or so after using them.

So your saying I should spray the entire bottle into a paper bag and then place it under my nose for 10 minutes?

Bet I wont care what color the figures are afterward

It's easier just to spray the paint directly into your nostril.

Not wanting to argue, but I'd advise against spraying outside - you'll get bugs and bits of dust stuck in the paint. Just make sure the room is well ventilated.

I regret giving the utility "spraying" room to my gf to use as an art room. spraying outside is a real pain as I dont get a lot of chance due to rain / heat / wind anymore. but i suppose it was only fair.

I find it's always best to make sure you have a small pot of paint of the same colour so any missed areas can be covered TK. I only use either Skull White or Chaos Black or both depending on what I am painting.

Also, if you ever shot in the chest, be sure to lie on your side. That way only one lung will fill with blood.

I suppose that would depend on where you live. We don't get much gun crime over here luckily.

And never run with scissors - even if they are round tipped ones.