Blood for the Baron!

Oh this is gonna be good un Andy

Need I say "Paint it red!"

Your being very creative recently, what are they putting in the water round your neck of the woods?

Thundershot wrote: Oh this is gonna be good un Andy

Need I say "Paint it red!"

Your being very creative recently, what are they putting in the water round your neck of the woods?

This wont be red ! its for my series one germans.

Ive added a few bits since that last pic, might even get finished tonight or tomorrow.

This is coming on nicely andy! Where did you get the white plastic for the front?

Looking good, Andy. Look forward to seeing it when its done.

Is this the sort of effect you're going for Andy?

Looking good, I did something similar with a soldier force half track a while ago and added cut down mobat tracks on the back but never got round to finishing it...

mark wrote:This is coming on nicely andy! Where did you get the white plastic for the front?

The white plastic is cut from a sheet of 3mm Nylon. I often find small offcuts lying around at work which come in handy.

Thundershot wrote:Is this the sort of effect you're going for Andy?

3731958130_d30245c629.jpg

Something like that ...... hopefully !

The Kraken Wakes wrote:Looking good, I did something similar with a soldier force half track a while ago and added cut down mobat tracks on the back but never got round to finishing it...

I could have done with some larger tracks, the ones im using are from a Havoc and are a bit shorter than I would have liked, but im working round it.

Any plans to finish yours ?

Not unless I get a new base vehicle or more of the same ones as these are a bit buggered now... Was one of my first customs and am not too happy with it...

Andy1672 wrote:

-

..................... TOP TIP ...... never attempt to scratch build !

- HA!

Very impressed so far Andy.

And impressed that your even trying to scratch build!

That will take an awful lot of work, but your clearly doing a mighty fine job!

Good luck with it, I very much look forward to seeing the completed thing!