Blood for the Baron!

The shaft is solid enough, but the top bit that fires the rockets keeps sagging.

Does anybody else have the same problem?

have you tried cleaning it lately?

Well, it usually works for me to grab the bits on the side and spead them out, then take the actual launcher and just point it up a little. Then release the sides and they should hold it in place, nice and straight.

And I get the blame for all the filth round here!!!!

Just be careful the bazooka doesn't go off in your hand prematurely. If it's not been let off for a while, they are prone to doing so I understand - could result in a nasty mess on your helmet Baron.

I knew it was too good to be true. I expect you feel a lot better now, Steve?

Thanks for the tip volleydan!

[quote="volleydan"]I can do it. Just PM me the item number and your maximum bid and I will bid for you. If I/you win, I will pay for it and then then send you the total including re-shipping once I receive it and get a quote from the post office. I recently did this for Golden Puma, and hopefully he has his Firefly figure by now.

Just sent you a pm to say he arrived and to say thankyou, if anyone else wishes to capitalise on Dan's generousity rest assured you'll be in good hands.

SteveD wrote:And I get the blame for all the filth round here!!!!

Just be careful the bazooka doesn't go off in your hand prematurely. If it's not been let off for a while, they are prone to doing so I understand - could result in a nasty mess on your helmet Baron.

Droopy missile?
Premature bazookas?

I've got treatments for them both!